[SkeeterRon]

Gentlemen,

I purchased this torch for a side job that's now complete. It's an awesome torch. Cuts clean like a Plasma. Uses less gas then standrad torch (4psi).

This is the torch your see NASCAR and INDY pit crew use to cut body fenders and bolts.


Below are links to two web sites selling the same torch, They are selling them between $295.00 to $495.00. I paid $300.00. I'm Asking $200.00 or BO.

http://www.cut-like-plasma.com/
http://www.aircraftspruce.com/catalog/topages/weldingtorch.php


The revolutionary design of the Henrob 2000 Torch makes it the ideal welding torch for aircraft construction. Henrob 2000 allows less oxidation, minimal flux, reduced press- ures and substantial materials savings. Fewer tips are required and hose fatigue is lessened. Perfect for steel & aluminum welding and cutting. Highly recommended by many aircraft builders. Formerly known as Dillon Mark III.

The Henrob 2000 Torch cuts steel like plasma - welds like TIG. Welds most difficult metals including aluminum, stainless steel, chrome moly, cast iron, sheet metal and more... Up to 50% - 70% gas savings - Made in the USA

I've seen this torch cut 4" plate steel. I used it on 1/4 steel.

I also have a NEW portable Torch set (with out the torch) Oxy/Acet tanks (OX 20/Acet MC sizies) are full with new gages, carrying case and hose. Asking $100.00

Thank you for looking...

Call me if you have question 860-982-5028, Ron
_________________
Sleep...Eat...Fish!!!!! Then do it all over again.